YSE1000 Controller

This controller has been designed to replace “Tab Stop”, “Velog” and “Premier” and other controllers on all Eaton Leonard GP, MP, VB and HP Series Automatic Tube bending machines. The system is also capable of being installed on a range of early and late model three axis automatic bending machines. Contact us for evaluation and capability.

The YSE1000 is based on a concept of a touch screen PC linked to a small, fast, real time controller that improves machine process timing over long production runs by decreasing turnaround errors.
--------------------------------------------------------------------------------
YSE1000’s features. :

Console Switches (10) oil and watertight, Industrial quality control switches;
Machine Inputs to the YSE controller are; hydraulics complete, hydraulics on, oil over temperature, oil at temperature, mandrel retracted, boost retracted, pressure die retracted, safety mat, carriage (DBB) encoder, collet (POB) encoder, bend arm (DOB) encoder, and RS485 communications.
Outputs from the machine controller are carriage (DBB) brakes, collet (POB) brakes, clutch, bend arm servo amplifier, fail safe relay and solid state relay board
Automatic control functions. Solid State Relay Board assembly contains 16, readily available Grayhill 70G-OAC5 relays with integral fuses and LED “on” function.
Enable the following functions: hydraulics enabled, clamp in, clamp out, pressure die in, pressure die out, boost forward, boost return, warm up, pressure die set pressure, pressure die low pressure, bend arm, high pressure, low pressure relief, mandrel lube, collet close, mandrel forward, mandrel return
Machine Manual Operating buttons:
Manual allow - forces two hand manual operation
Close collet - manual operation of the tube grip collet.
Open collet – opens tube grip collet
Emergency Stop – Safety shutdown. Provides redundant shutdown of Hydraulic pumps, valves, servos and control functions.
Start - (left and right) Starts an automatic or single step bending program
Stop - aborts any currently active operation
Hold - pauses any currently active operation - initiates hold mode
Motor On -starts the hydraulic pump
Load for sending all mechanisms to their starting location for bending a new part
Foot Switch and remote start capability.

--------------------------------------------------------------------------------
Pricing:
--------------------------------------------------------------------------------

YSE1000 System, GP and MP

YSE1000E (extended) HS, HP and others

Installation service and training (4 – 5 days)

Complete machine rewiring

Industrial encoders, oil tight, each (three required)

Benderlink for YSE1000, VMM interface

EMAIL

EMAIL